Assemble Everything

Created: Sunday, August 5, 2007, posted by Geetesh Bajaj at 4:19 pm



Before you start inserting your Flash movie on a PowerPoint slide, you should follow these good practices to assemble all the stuff:

  1. First of all, make sure that you have all the four prerequisites in place.
  2. Place your saved PowerPoint presentation in a new or existing folder. Copy your Flash SWF file to this folder.

    If you need to insert the Flash SWF file into a new presentation, then save the Flash SWF file into a new folder. Then create a new presentation and save it in this folder.

  3. If the presentation is not open, launch PowerPoint, open the presentation and navigate to the slide where you want to insert a Flash SWF movie.
  4. Thereafter, the process in which you insert the Flash SWF will differ a little if you use PowerPoint 2007 or a previous version of PowerPoint.

If you use a version of PowerPoint that’s pre-2007, proceed here…

PowerPoint 2007 users should proceed here…


Related Post

Enable the Developer tab in the Ribbon The options that allow you to insert Flash movies in PowerPoint 2007 (and maybe later versions) are found in the Developer tab of the Ribbon.By defaul...
Insert the Control (PowerPoint 2007) I'm assuming you have the Developer tab of the ribbon enabled, have all the prerequisites installed, and have assembled everything in one folder.Now y...
Insert Flash Resources Although this site is the most complete resource of Flash-in-PowerPoint information anywhere, I wanted to share other resources with you as well:Indez...
Using FlashBack In a previous post, I introduced FlashBack -- a PowerPoint add-in that rewinds (and replays) Flash movies in PowerPoint slides.Here's a step-by-step t...

Microsoft and the Office logo are trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries.

Plagiarism will be detected by Copyscape

© 2007-2019, Geetesh Bajaj - All rights reserved.

blog stats
since September 16, 2009